Stands

From Onewheel.Wiki
Revision as of 04:58, 1 April 2020 by Craftandride (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search

Craft&Ride Trunk Stand for Onewheel™

The Craft&Ride Trunk Stand for the Onewheel+ XR, Onewheel Pint, Onewheel+, and original Onewheel is available now here.

  • Safely secure your Onewheel and prevent it from tumbling in your vehicle
  • Retails for $64.99
  • Available to ship immediately (call or text Nick at +1 (909) 609-5719 to inquire about same day shipment)
  • View 2,684+ verified reviews of Craft&Ride products and service here.

Craft&Ride OG Stand for Onewheel™

The Craft&Ride OG Stand for the Onewheel+ XR, Onewheel Pint, Onewheel+, and original Onewheel is available now here.

  • Available in 2 colors including Mahogany and Black
  • Retails for $64.99
  • Available to ship immediately (call or text Nick at +1 (909) 609-5719 to inquire about same day shipment)
  • View 2,684+ verified reviews of Craft&Ride products and service here.

Craft&Ride X The Float Life Foundation Stand for Onewheel™

The Craft&Ride X The Float Life Foundation Stand for the Onewheel+ XR, Onewheel Pint, Onewheel+, and original Onewheel is available now here.

  • Black powder coating finish with painted C&R and Float logos
  • Retails for $64.99
  • Available to ship immediately (call or text Nick at +1 (909) 609-5719 to inquire about same day shipment)
  • View 2,684+ verified reviews of Craft&Ride products and service here.



Official "Wave" stand

Slick looking stand. However, you may not have clearance if your board has float plates installed.

3rd Party solutions

Folding Guitar Stands @ Amazon

SilverStand

Compatible with the Onewheel+ and original Onewheel. A laser-cut aluminum stand made specifically for the Onewheel that allows you display your board vertically. Allows for a smaller footprint than laying it on the ground, and prevents the black smudges on the wall which typically occur when propping it against the wall. (Created and assembled in the U.S. by Greg DiGenti.)

The Float Life Foundation

The Float Life XtraRad Stand

Groovyruvy's Black Steel and Aluminum Anchor Stands

DIY

You can easily make a wooden stand like this one:

Wooded stand.jpg

It is made of hemlock fir. The bottom is 25cm and the height is 23cm.

The small piece on the front is glued from the t. op