Difference between revisions of "Stands"
From Onewheel.Wiki
(→==) |
|||
| Line 1: | Line 1: | ||
=== [https://onewheel.com/collections/accessories/products/onewheel-wave-stand | === [https://onewheel.com/collections/accessories/products/onewheel-wave-stand Official "Wave" stand] === | ||
Slick looking stand. However, you may not have clearance if your board has float plates installed. | Slick looking stand. However, you may not have clearance if your board has float plates installed. | ||
| Line 10: | Line 10: | ||
''Compatible with the Onewheel+ and original Onewheel.'' A laser-cut aluminum stand made specifically for the Onewheel that allows you display your board vertically. Allows for a smaller footprint than laying it on the ground, and prevents the black smudges on the wall which typically occur when propping it against the wall. (Created and assembled in the U.S. by Greg DiGenti.) | ''Compatible with the Onewheel+ and original Onewheel.'' A laser-cut aluminum stand made specifically for the Onewheel that allows you display your board vertically. Allows for a smaller footprint than laying it on the ground, and prevents the black smudges on the wall which typically occur when propping it against the wall. (Created and assembled in the U.S. by Greg DiGenti.) | ||
==== [https://craftandride.com/collections/frontpage/products/craft-ride-single-stand | ==== [https://craftandride.com/collections/frontpage/products/craft-ride-single-stand Craft&Ride Single Stand] ==== | ||
==== [https://craftandride.com/collections/frontpage/products/craft-ride-double-stand-for-onewheel | ==== [https://craftandride.com/collections/frontpage/products/craft-ride-double-stand-for-onewheel Craft&Ride Double Board Stand] ==== | ||
==== [http://thefloat.life/product/tfl-foundation/ The Float Life Foundation] ==== | ==== [http://thefloat.life/product/tfl-foundation/ The Float Life Foundation] ==== | ||
| Line 19: | Line 19: | ||
=== DIY === | === DIY === | ||
You can easily make a wooden stand like this one: | |||
[[File:Wooded stand.jpg|left|thumb]] | |||
It is made of hemlock fir. The bottom is 25cm and the height is 23cm. | |||
The small piece on the front is glued from the t. op | |||
[[Category:Accessories]] | [[Category:Accessories]] | ||
Revision as of 17:51, 3 October 2017
Official "Wave" stand
Slick looking stand. However, you may not have clearance if your board has float plates installed.
3rd Party solutions
Folding Guitar Stands @ Amazon
SilverStand
Compatible with the Onewheel+ and original Onewheel. A laser-cut aluminum stand made specifically for the Onewheel that allows you display your board vertically. Allows for a smaller footprint than laying it on the ground, and prevents the black smudges on the wall which typically occur when propping it against the wall. (Created and assembled in the U.S. by Greg DiGenti.)
Craft&Ride Single Stand
Craft&Ride Double Board Stand
The Float Life Foundation
Groovyruvy's Black Steel and Aluminum Anchor Stands
DIY
You can easily make a wooden stand like this one:
It is made of hemlock fir. The bottom is 25cm and the height is 23cm.
The small piece on the front is glued from the t. op